Nothing changed on my truck. What is hitting/rubbing. Did you get an alignmemt yet?

 

What's your offset on your wheels?

 

22x9.5 with 30mm offset

i cant see anything hitting or rubbing, and i didnt get an alignment, it is very close to where it needs to be with just swapping the spindles. but i will probably do it next week, sucks having a real job that i cant just take the day off to go work on my truck...

 

Not to sure what to tell you. I have no problems at all. When I was at 4.5" drop I didn't have issues then either. I guess check and make sure everything is installed correctly. Just a thought, did you put the tie rods in upside down? Just guessing...

 

Everything was installed correct, ill have to try to get under it and see if anything is rubbing that I didn't notice before

 

So I received my issue of street trucks yesterday and I actually made the T_S_S ad! It's cool to see my truck in the mag......Even if it is a tiny pic

Thanks T_S_S!!!

 

pretty cool, just sucks that people will see your truck and figure they will be that low if they buy a "kit" from them, lots of research and trial and error went into it

 

should scan it and put it in here so we can see!!
congrats jsvo

 

Congrats

 

here it is......

 

Pic doesn't work

 

It works for me.

I will add another link.

 

Congrats, J! Rig is tight! - Og

 

forgot to mention after i dropped the rear of my truck i can now steer the full range, must have been the caster was so messed up being 2" lower in the front it just didnt like turning that far

 

Thanks!

That sounds weird. But as long as it's fixed that is all that matters!