Hey JBMX dig the cover and wing. Looks sweet!
[IMG][/IMG]

 

I'm pretty sure once you take the steps off the bracket it shouldnt be hard ranger

 

Looks good ranger. You should pull the step bars up real tight, and in to look similar to the harley bars.

 

That's the plans guys, hopefully I get this weekend off, no wife to nag, perfect Saturday project!!

 

Ok guys I've got a question maybe stupid, but I cut my front springs to lower it and I didn't realize I cut the driver a lil shorter than the pass, think less than half inch difference but would that cause my rear end to have be higher than the other? Have one leaf removed hangers and extended shackles to 3" my buddy fabricated for me.

 

Yes if you have the front off and lower on one side it will effect the opposite side rear causing it to be higher. That's why should should be the correct replacement springs and not hack things up. You also understand that by cutting a coil off the springs that effects the overall spring rate and will effect the way the truck rides and handles.

 

Well the ride and handling hasn't been to bad, it's pretty good ride quality. But I'm wanting to get some spindles n springs. But I'm also leaning towards to bagging it too.

 

Trying out a new wax. Looking for a harder, longer lasting wax. Might have found it.

 

Wow!!!! Truck looking sweet and clean c_ulater!

 

I thought all the blue tape was chrome and just yelled "NOOOOOOOOOOOOOOOOOOO" in my head

Edit: Danielle also said eww look at all the chrome...

 

So did I.

Greg what wax are you using?

 

I have a 1998 f150 4.2 v6 5pd shortbed plan cab stepside i can not find a 3/5 kit for my truck.What am i doing wrong i like the looks of the 2/4 kit but i really want that 3/5 look. Can anyone help me!! Thanks

 

figure ill get back into this thread since i finally logged back on ha

 

x2 lmao!!!!!

 

DAMN!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!