xentec HID kit
Senior Member
Joined: Jun 2006
Posts: 2,970
Likes: 0
From: Huntsville/Cypress, TX
Originally Posted by IDNC76
can you guys help me out, i just purchased the xentech kit from hid4u off ebay and the 9005's plugged right up, but the h13's you have to stick these to prongs into the stock harness, how did u do it, they wont fit,should i try and trim them down and stick em in there, and tape it up good??
and which prongs go where ???
and which prongs go where ???
Senior Member
Joined: Jan 2007
Posts: 4,039
Likes: 0
From: NJ
Originally Posted by MmmBuckles
thats what i would do. red should go in the middle hole. and the black in the right side hole
i stuck the black in the middle and the red on the right. it works fine, but the high beam icon is lit up, on my gauge cluster. i ll have to give it a re wiring later to figure it out.excellent kit though, everything lights up at nite, its amazing, i love driving at nite now
Senior Member
Joined: Jun 2007
Posts: 1,618
Likes: 1
From: Texas
Originally Posted by IDNC76
it was quite easy. i used pylers and just smushed the prongs till they fit i stuck the black in the middle and the red on the right. it works fine, but the high beam icon is lit up, on my gauge cluster. i ll have to give it a re wiring later to figure it out.
excellent kit though, everything lights up at nite, its amazing, i love driving at nite now
i stuck the black in the middle and the red on the right. it works fine, but the high beam icon is lit up, on my gauge cluster. i ll have to give it a re wiring later to figure it out.excellent kit though, everything lights up at nite, its amazing, i love driving at nite now
Senior Member
Joined: Jun 2007
Posts: 1,618
Likes: 1
From: Texas
Originally Posted by IDNC76
does anyone elses lights flicker when u hit the open button on ur remote??? or did i wire wrong??
Junior Member
Joined: Jan 2008
Posts: 2
Likes: 0
From: Annapolis, MD
Weird Issue with HID Headlights
Guys, I hope you can help. I ordered the bixenon H13 kit from Flashplus, and got a plug that would not work with my headlights. So I came on here and found another thread where someone had the same problem. I cut the plug from the kit and the OEM headlight light plug, and spliced everything together. Everything works, but when I turn on the (stock) fog lights, the HID's move into a middle position between high and low. I'm pretty sure this will cause some issues with blinding people.
Anyone else have this problem?? With the fog lights off, everything works perfectly, but the minute I turn the fogs on the headlights move into some weird middle position.
Thanks!
Anyone else have this problem?? With the fog lights off, everything works perfectly, but the minute I turn the fogs on the headlights move into some weird middle position.
Thanks!
Thread Starter
|
Senior Member
Joined: Aug 2007
Posts: 2,472
Likes: 1
From: Des Moines, IA
the problem you are having is the fog lights sharing a ground with the high beams. you need to provide a permanant ground for the fog lights. follow these instructions http://www.landstromsfoundry.com/Tec...Foglights.html
and it will fix the problems. good luck!
and it will fix the problems. good luck!
