xentec HID kit
Technical Article Contributor
Joined: Aug 2006
Posts: 7,862
Likes: 0
From: Northern California
Originally Posted by recon_sct
I have a question for you guys running Bi-xenon kits (hi and lo beams) How do like the output of the high beams? My low beams work fairly well but when I turn on the high beam they point straight to the ground! I thought I might have the bulbs in upside down but tore everything apart and they are in right (only one way to go in) I checked to make sure the bulbs are working properly, when on low beam the lights are straight and when I hit the high beams the bulbs telescope up. Not sure whats going on, but thought maybe one of you would have run into this.
Thanks for any help!
Thanks for any help!
Registered User
Joined: Jun 2002
Posts: 170
Likes: 0
From: Illinois
For the guys saying they are getting flashed when they have their fogs on. I read somewhere thats pretty common because there is nothing sitting in front of the bulb like in the headlight housing. To fix that they took some aluminum foil and wrapped that around the front of the light to knock down the glare.
Just someone else's fix I thought I would throw out there. I try and find the post that had that.
Just someone else's fix I thought I would throw out there. I try and find the post that had that.
Senior Member
Joined: Oct 2002
Posts: 812
Likes: 0
From: R
Originally Posted by mSaLL150
Yes it is just the internal solenoid straightening. All the Xentec Bixenon kits do this.
Last edited by Ray21; Nov 1, 2013 at 07:24 PM.
Registered User
Joined: Jun 2002
Posts: 170
Likes: 0
From: Illinois
Originally Posted by Melovidov21
I installed my kit over the weekend... install went pretty well. They are flat out bright! I was skeptical but am now impressed.
Does anybody elses switch from low to high before shutting off?
Does anybody elses switch from low to high before shutting off?
Technical Article Contributor
Joined: Aug 2006
Posts: 7,862
Likes: 0
From: Northern California
Originally Posted by krazyballer
How come most of the bulbs are for low beam,i cant find 9004in high/low or do all the kits for high/low
Senior Member
Joined: Jan 2007
Posts: 4,039
Likes: 0
From: NJ
can you guys help me out, i just purchased the xentech kit from hid4u off ebay and the 9005's plugged right up, but the h13's you have to stick these to prongs into the stock harness, how did u do it, they wont fit,should i try and trim them down and stick em in there, and tape it up good??
and which prongs go where ???
and which prongs go where ???