5.0 engine cover kit
#1
5.0 engine cover kit
http://item.mobileweb.ebay.com/viewi...d=81813622329#
Has anyone installed one of these kits in their 5.0 yet. I contacted Roush and they said the engine cover would fit but the coil covers would need Dowel pins which neither they nor ford have a part number for. I think this would look rad.
Posted from F150online.com App for Android
Has anyone installed one of these kits in their 5.0 yet. I contacted Roush and they said the engine cover would fit but the coil covers would need Dowel pins which neither they nor ford have a part number for. I think this would look rad.
Posted from F150online.com App for Android
#2
you have to reroute the two hoses on top before the intake cover would fit. i have the coil pack covers on mine though. i just put some screws on the heads and jb welded them in place. the screw heads just pop into the rubber grommets on the covers. also if you dont want the cover sitting too far above the intake manifold then you have to do some trimming to one side of it
#3
Originally Posted by jooman07
you have to reroute the two hoses on top before the intake cover would fit. i have the coil pack covers on mine though. i just put some screws on the heads and jb welded them in place. the screw heads just pop into the rubber grommets on the covers. also if you dont want the cover sitting too far above the intake manifold then you have to do some trimming to one side of it
Posted from F150online.com App for Android
#7
HotLap - Joe that looks sweet
...how are you liking the Rousch CAI?
I opted to add a pre-filter to keep-down the BIG chunks.
And will eventually replace the oiled-filter with a dry version.
How much louder is the intake noise while driving?
But then ... I don't tow much.
.
Last edited by gDMJoe; 02-08-2013 at 11:29 PM.
Trending Topics
#11
#13
#14
#15
Darn!! Now I find out after receiving the gray. Oh well, the gray actually doesn't look too bad and will still dress up the engine bay. Thinking of painting the cover Tux black to match the exterior color. Also probably going to paint the stock intake housing Tux black as well. Installing the rear wheel fender well liners - MUCH better look than everything being wide open. Passenger side done and looks factory!!