Well broke the binding on the board so its basically fried and I'll probably heal up in about a couple weeks, not as bad as earlier this season when I ruptured my ear drum, but hopefully I didn't tear my knee too badly. Luckily the board is from Cabela's and they'll take back almost anything so I'll probably just get a new one.

 

OK, I'm going to set up a date of October 12 for a "maintenance party".
My truck is due for tranny fluid and filter, fuel filter, rear end, transfer case, and plugs. I don't anticipate getting all of these done, but we can try, right?
I have a 3 car garage, air compressor, sockets, tunes, tv, refrigerator, etc...
Who wants to help, join in, or stand around and offer wisdom?

 

Im sure I can find something to do with my truck. Or else sit around and smoke cigarettes

 

Hey Guys - I just wanted to let you know I might have recruited a new member to our area. A nice guy by the name of Matt called me up to ask if I can reprogram for his oversized tires (35's). I told him I can get it within 2-3 mph but that's about it unless you get an Edge programmer or whatnot. I was guessing it was just a leveled out truck with 35's, but this is what it looks like: (camera phone pics)













Very Nice!! Full 6" BDS suspension lift, 35" Nitto's, 18" Mazzis Hulks?? (not sure what wheels).

I told him about F150online.com and he said he had been to this site before. That's where he got some of his ideas from. So I told him to check out this Midwest category and told him about our recent get-together this past weekend. Hopefully he will show up on here so we can add another sweet truck and member locally.

 

Haha, nice job.

Good looking truck too. Hopefully he stops by.

 

I am liking the looks of that truck, hopefully he will show up in here then.

And I will check and see what I have going on the 12th. I am not sure I might be out of town its either that weekend or the following.

 

That's a nice rig

 

has there been any talk of when the next get together will be?

 

This would be at my house in Omaha. I'll give directions as it gets closer. You'll drive through Gretna, go almost to Elkhorn then east a couple of miles. Little traffic to worry about.

 

Sounds good, I'll have to see if I have anything going on that weekend.

 

There is going to be a "wrenching party" it sounds like Jumpn is trying to put it together up at his place in Omaha on Oct 12.

 

Im in. jump n im practly your neighbor

 

I'm in Briar Hills subdivision, 174th and Blondo, where are you? What do you drive?

 

Too bad you didn't find this thread just a tad bit sooner, you could have came to our last meet.

 

192nd and Blondo I drive a 01 screw dark blue