Let's start over......
Good grief! Don't even have lights in that barn!
That place is a mess. finding a wrench is a challange, doubt I find a DMM. Couldn't locate the battery charger last night and there's supposed to be two of them. There were four tractors in there and hard to move around. Three will be gone today, so that will help in moving around. never seen so much junk and it's a dirt floor.
That place is a mess. finding a wrench is a challange, doubt I find a DMM. Couldn't locate the battery charger last night and there's supposed to be two of them. There were four tractors in there and hard to move around. Three will be gone today, so that will help in moving around. never seen so much junk and it's a dirt floor.
__________________
Jim
Jim
mule carb diagram.....

not the slide type
source link for image http://www.atvworks.com/mulefish.asp...odID=KAF620-A6

not the slide type
source link for image http://www.atvworks.com/mulefish.asp...odID=KAF620-A6
Last edited by 88racing; Jun 19, 2012 at 11:18 AM.
I'll have to go take a looksie...
Yep, he went a bit bonkers. When he received the invite, he was so excited about the nomination. His name should be FX4TWISTEDNUTJOB. He did cause a little excitement.
__________________
Jim
Jim
All the good stuff has been removed. Deleted 38 posts this morning.
__________________
Jim
Jim

mule carb diagram.....

not the slide type
source link for image http://www.atvworks.com/mulefish.asp...odID=KAF620-A6

not the slide type
source link for image http://www.atvworks.com/mulefish.asp...odID=KAF620-A6
__________________
Jim
Jim
thank goodness I used screen shot and saved them...
You're very welcome
BTW.....that link shows a lot of diagrams with part numbers for most of the vehicle....

BTW.....that link shows a lot of diagrams with part numbers for most of the vehicle....
It would be a one way ticket for him and a round trip for me







