Too much?
Thread Starter
|
Senior Member
Joined: Oct 2007
Posts: 560
Likes: 0
From: Londonderry, NH
thanks, good to know. Can I assume the Maggie tips are higher quality, so they shouldn't have a problem?
Just keep up on maintaining their surface. Mine looked like brushed silver after a year of un-cared for abuse. They lost their shine and were rubber & tar coated. I'm sure they could have been saved but it would have taken a ton of effort.
Thread Starter
|
Senior Member
Joined: Oct 2007
Posts: 560
Likes: 0
From: Londonderry, NH
Got my goodies, just waiting on the tips now, should be here monday! Super excited to hear it now. I went with the hi-flows with the o2 nut, not sure if that's an issue, I guess if it is worse case scenario I plug it off and have new nuts welded on further down. I don't see any problem, although I just noticed right on the box it says "pre OBDII, 1995 and earlier" or something...
Last edited by ryan42680; Oct 11, 2011 at 06:14 PM.
Thread Starter
|
Senior Member
Joined: Oct 2007
Posts: 560
Likes: 0
From: Londonderry, NH
Here are the tips, love em so much
and it's all gonna exit just like KR-Texas' Raptor, though maybe just a tad more of those sexy tips showing, same slight outward angle though...hopefully by later next week I'll have it up!
and it's all gonna exit just like KR-Texas' Raptor, though maybe just a tad more of those sexy tips showing, same slight outward angle though...hopefully by later next week I'll have it up!
Technical Article Contributor
Joined: Apr 2009
Posts: 10,697
Likes: 14
From: In the fast lane from LA to Tokyo...
Got my goodies, just waiting on the tips now, should be here monday! Super excited to hear it now. I went with the hi-flows with the o2 nut, not sure if that's an issue, I guess if it is worse case scenario I plug it off and have new nuts welded on further down. I don't see any problem, although I just noticed right on the box it says "pre OBDII, 1995 and earlier" or something...
Thread Starter
|
Senior Member
Joined: Oct 2007
Posts: 560
Likes: 0
From: Londonderry, NH
I won't mind the drone...truck only goes out once a week or so, and average drive time being 30 minutes or so. Every once in a while we take a trip in it, but the wife prefers the Edge for travel.
Thread Starter
|
Senior Member
Joined: Oct 2007
Posts: 560
Likes: 0
From: Londonderry, NH
I know it's a crappy vid, sorry for the quality...if I can get a better one before the new set up I will, but I rushed this for comparison of what's to come.
http://www.youtube.com/watch?v=b4Yx08GRFV4
http://www.youtube.com/watch?v=b4Yx08GRFV4
Last edited by ryan42680; Oct 11, 2011 at 06:36 PM.
Thread Starter
|
Senior Member
Joined: Oct 2007
Posts: 560
Likes: 0
From: Londonderry, NH
SO I got a better quote, I supply the hi flows, x pipe, 4x14 magnapacks, and tips, he'll install using T304 ss, smooth bend, dumped out like in post #21 (KR-Texas' Raptor) $400. So I'm gonna schedule for early next week, I'll have my comparison videos up hopefully by midweek, I'm stoked! I'm happy my whole exhaust will be stainless.......and hopefully sound mean as all hell 
, also after it's done get some high heat clear rattle can paint and seal the welds just in case, so rust won't happen
