Going to duals
Technical Article Contributor
Joined: May 2007
Posts: 1,221
Likes: 0
From: St. Louis, MO
Jegs makes a similar one. Probably the same exact one actually.
http://www.jegs.com/i/JEGS-Performan...ductId=1270359
http://www.jegs.com/i/JEGS-Performan...ductId=1270359
Thread Starter
|
Senior Member
Joined: May 2006
Posts: 438
Likes: 0
From: Lake Mary, FL
Installed and very satisfied. Not very audible at idle, somewhat at cruise and can hear it will at acceleration. You won't hear me coming miles away, but it has a great tone which is what I wanted for this truck. Leave the loud for my big truck.
-Curtis-
-Curtis-
Senior Member
Joined: Feb 2004
Posts: 10,390
Likes: 10
WTF? 
The very definition of true mandrel bending is to preserve the cross-section and diameter integrity throughout the bend.
Where TF is dat Emperor dude?????
MGD
The very definition of true mandrel bending is to preserve the cross-section and diameter integrity throughout the bend.
Where TF is dat Emperor dude?????
MGD
Senior Member
Joined: Aug 2008
Posts: 4,778
Likes: 10
From: Douglasville GA
He didn't state that he was or wasn't going to have it mandrel bent when I made that post.
. Most everyone who gets pipes bend has a shop thats all standard, as in 16 gauge aluminized and crush bend. I would go 2.5" in this case,