will a jumpseat fit my tuck.. please i need advice!!!?!?!
#1
#4
Whoops boomer--had a loooooong night last night lol. Yes, the jumpseat from the ext cab will fit, just dont think you'll have the wires in your truck to run the rear 12v power point like the SuperCabs have. Other than that, it's four bolts on the floor and they use the same bracket, so you should be in business. Sorry again about the confusion with my first post.
#5
#6
as long as your old jump seat is separate from your passenger and driver seats, it will fit no problem. to remove your old jump seat, you will have to remove the part you sit on by grabbing the front of it and pulling up. after the seat is removed you will see four bolts, just remove those and pull your old jump seat out. reverse the process putting the new seat in and you will be on your way.
it's really not necessary to wire up the 12V hook up since you would probably never use it. but if you wanted, you would have to find a wire harness out of a truck that is equipped with it because it takes specific plug to give the outlet power if i recall correctly.
it's really not necessary to wire up the 12V hook up since you would probably never use it. but if you wanted, you would have to find a wire harness out of a truck that is equipped with it because it takes specific plug to give the outlet power if i recall correctly.
#7
Trending Topics
#9
#10
i'm assuming you already have two 12V outputs just as my regular cab. if not, quit reading now. If you do already have two, and those aren't enough you need to consider hardwiring some stuff. adding one to your console would be a waste of time, money and energy plus risking hacking up your new console. and you have to remember, if you drill a hole inside the compartment you will be making a hole exposing your seat cushion. it would be hard to find a place to make a hole with enough depth for your wires and the outlet itself..
#12
I have played around on Ford Parts Online and not come up with anything yet. Best bet is to talk to your local dealership and have them check their parts catalog. With your truck being an XL, there were probably no factory provisions set up for such a swap...just talk to your dealership and let us know...