Trans Fault - Temp sensor?
#1
Trans Fault - Temp sensor?
I just swapped in my PI torque converter and I'm getting the Trans fault code and blinking OD light.
Shifts fine, even going into OD.
I noticed when I hooked up my diablo and try and read information it says my tranny temp is 380 celcius and getting no voltage from the trans temp sensor. So I'm assuming it must of got unhooked?
Anyone have pictures of what I need to look for when i drop the pan?
found this diagram to check the voltage outside to confirm. I'll do that first thing in the morning..
Shifts fine, even going into OD.
I noticed when I hooked up my diablo and try and read information it says my tranny temp is 380 celcius and getting no voltage from the trans temp sensor. So I'm assuming it must of got unhooked?
Anyone have pictures of what I need to look for when i drop the pan?
found this diagram to check the voltage outside to confirm. I'll do that first thing in the morning..
Last edited by FATHERFORD; 05-16-2010 at 12:46 AM.
#2
#3
#4
I dropped the pan again and made sure all the connections were good(incase I knocked something around when pulling the filter). I checked for any pinched wires or un hooked connections in the pan. Also checked like you said(i read in some searches) for pinched wires on the upper parts of the transmission. Nothing. Harness was loose except for being bolted down on the driver side upper bolt.
I just left the truck on the lift and I will have to tackle it next weekend.
Last edited by FATHERFORD; 05-16-2010 at 06:14 PM.
#5