Will my 305's look good under a 6" Fabtech?
some crappy cell phone pics after tires were mounted. it was too dark to take pics with digital cam when i got home. i'll post some nicer ones tomorrow. truck did go up about 2" with these tires (easily). so much for my trying to bring her down.




took a quick shot before i pulled out this morning for work, still trying to get used to the new look. tires aren't loud as i expected, actually pretty quiet.
before the westin nerf bar, truxedo tounneau, and mickey t 35's on 17's

after
before the westin nerf bar, truxedo tounneau, and mickey t 35's on 17's

after
Dnasty777
i bought the truck at an auction listed as "severe water damage", the 6" Fabtech lift was already installed on it. i won the bid for about half the cost of what i see this lift kit sold for. i spent about $2,500 to get in running (3 piston, 2 connection rods replaced), lots of water drained/flushed from all fluids, Gem module replaced, instrument cluster replaced. the parts totaled about $1,000 and the labor $1,500.
then i spent about $2,000 on tires, tounneau, step bar and bed mat.
i'm done man, time to start saving again.
i bought the truck at an auction listed as "severe water damage", the 6" Fabtech lift was already installed on it. i won the bid for about half the cost of what i see this lift kit sold for. i spent about $2,500 to get in running (3 piston, 2 connection rods replaced), lots of water drained/flushed from all fluids, Gem module replaced, instrument cluster replaced. the parts totaled about $1,000 and the labor $1,500.
then i spent about $2,000 on tires, tounneau, step bar and bed mat.
i'm done man, time to start saving again.
Those do look really good. x2 on the 10" wide wheel, that would look even better IMO. I can't find a decent 17X10 wheel any where in the 5x135mm bolt pattern. I'd love to lose my saw blade look and widen the stance while keeping my current BFG AT KO's





