Hello, I am looking at installing aftermarket gauges in my 01 supercrew and I would like to see some pictures of installs in 97-03 f150s. Mainly I want to see apillar pod installs, but I am up for seeing anything. Thanks in advance.

 

heres mine.

oil pressure, trans temp, vacuum, A/F gauge, sct livewire

 

I like how that looks! I have grey interior in my screw. So to use that a pillar 3gauge pod, you just had to remove the grab handle and the new pod attaches over the original one? Or how does this one attach? I did a 3gauge pod in a buddys duramax and thats how it attached.

 

thanks! this one replaces the stock pillar. i had to drill two holes i think. wasnt a big deal.

 

Here's mine ... Autometer full sweep electric gauges w/ Autometer pod. This pod fits over the stock pilliar ('99 doesn't have a grab handle on the driver side). I attached it double sided moulding tape ... https://www.f150online.com/forums/ar...9-f-150-a.html

 

Im debating between full sweep and half sweep right now. Im really leaning towards autometer because of how they have impressed me in the past.

 

I have ordered and received my Oil pressure, water temperature, and trans temperature gauges. They are 2-1/16 Electronic Short Sweep Autometer Phantom's. I also received and painted my Autometer 3gauge pillar pod.

 

nice! post up pics when you get them installed!

 

Will do! Still learning how to post pics up on here. Str8t Six: where and how should I tap in my switched 12V Power source for the gauges?

 

Custom made dash bubble https://www.f150online.com/forums/19...sh-bubble.html

 

^^pimp

 

i think i used my radio power wire to turn them on.

 

Showoff....

 

Go for glowshift.com gauges.

 

when doing the water temp, tranny temp, and oil pressure sensors...was there a good amount of fluid that came out of them?