Engine Blown!
Senior Member
Joined: Nov 2006
Posts: 2,068
Likes: 2
From: So. Cal.
Times have changed. My junk yard builds rock crawlers, puts 351w's into Jeeps & rangers, gears swaps daily, installs lift kits and is just pretty dam awesome!
They even put a built bottom end into my buddys 03 cobra that put down over 600 at the wheels. I honestly trust guys like these more that tear motors down everyday vs a tech at ford who once or twice a month tears into a motor while reading his book.
I'm not talking about a pick and pull type place. That would be a joke.
They even put a built bottom end into my buddys 03 cobra that put down over 600 at the wheels. I honestly trust guys like these more that tear motors down everyday vs a tech at ford who once or twice a month tears into a motor while reading his book.
I'm not talking about a pick and pull type place. That would be a joke.
Senior Member
Joined: Aug 2008
Posts: 1,075
Likes: 0
From: Yorba Linda, CA
ouch that was low blow.
Thread Starter
|
Member
Joined: Nov 2005
Posts: 51
Likes: 0
From: Cumming, GA
Saleen thanks for checking on that for me.
thanks to everyone for the replies. I am going to try and go get it tomorrow so I can check it out and get someone local to do it.
Is there anyone running 285's on the stock 17 inch wheels that can measure how wide it is from tire to tire. I have a friend that has a car hauler I can borrow but its only 80" wide.
thanks to everyone for the replies. I am going to try and go get it tomorrow so I can check it out and get someone local to do it.
Is there anyone running 285's on the stock 17 inch wheels that can measure how wide it is from tire to tire. I have a friend that has a car hauler I can borrow but its only 80" wide.
