ha j/k, but yeah its on:

my head ache rack which was the result of a Denny's in a nearby town closing down. nothing like food grade stainless

and my intake, just a red spectra intake and some parts from lows. had a heat sheild on it pulled it off for paint and never put it back on, I'll get to it later

 

Where is up north to you?

 

evansville indiana, I'm outa kentucky

 

I thought I seen KY plates in one of your pics. That's why I was asking, I'm in SW Ohio, SE of Cincinnati, so was wondering if it was around here you were referring to. I really like that bumper.

 

[QUOTE=Little Luke;4265023]ha j/k, but yeah its on:

my head ache rack which was the result of a Denny's in a nearby town closing down. nothing like food grade stainless


Looks like a damn tow truck with that bumper and those mudflaps, haha. Making it more beast of course

Good job with the fabrication

 

thanks. naw hell, I'm in union county in western ky, haven't been to ohio in about 5 years
lol, yeah, that was the old plate was off of the Shagon Wagon, not sure y everybody blacks out there lisence plate in the pics, but figure there is some reason so I did the same to my good plates

 

Would you be interested in fabbin' some rear bumpers to sell ??

 

well, got bored last night and made these:
kinda thinking that the front bumper will come out ike this

and if I have enough stainless pipe I'll make the tie downs attched to the headache rack.... trying to decide if I want to go with the black rocker panels or not


just some stuff I've been putting around

 

:owell, untill recently I've neglected my truck, but I've had it in the my shop for 3 weeks so thought I would take some pics.
Night shaded the tail lights, still need To do the 3rd brake light after I do an LED swap
Refinished and Polished my rims, gonna try and keep them clean this winter.

Picked these lights up off of ebay for 99 cents each (plus 7$ shipping.... but that doesn't make it sound as good). Tried cleansing one but still has a little yellow tint to it so I'm gonna pick up a coarser grit sand paper tommorrow to see if that does the trick. Can these thing oxydize from the inside of the lens?


Other than that I've just finished sevicing the whole thing and replaced the front brakes and rotors, which sucked because the rotors were seized the the hubs, so I had to remove the whole spindle and use my motivational device to get them off.

Now a question, should my brake pedal move about 4 to 5 inches with no actual braking action. since I've had the truck it has seemed like I have had to put my foot to the floor to slow down. Is this normal? If not what should I check.

Oh, now something is cherping on the lower, front passenger side of the motor, didn't feel like looking at it tonight.

 

I would just clear it, looks good like that

 

........ I really want to try this now. I have to repaint the rear bumper after winter anyways. Got rear ended and scratched my black paint.

 

That rear bumper is sweet!

 

thanks, really want to start on the front one.
I have everything for it except time.... and the 6 running lights and 4 fog lights.