new to the forums
http://www.v6f150.com/forums/showpos...&postcount=170
http://www.v6f150.com/forums/showpos...&postcount=172
http://www.v6f150.com/forums/showpos...&postcount=176
Last edited by dirtyd88; Feb 25, 2010 at 04:14 PM.
Can I have $2000? And some free time or money to install everything?? lol
I did find a guy in Houston with multiple 4.6 aluminum blocks and enough stuff to get started on a 4.6 4V swap!!! That about persuading my dad to pick on up and and having it as a project/learning motor....
I did find a guy in Houston with multiple 4.6 aluminum blocks and enough stuff to get started on a 4.6 4V swap!!! That about persuading my dad to pick on up and and having it as a project/learning motor....
Thread Starter
|
Member
Joined: Jan 2010
Posts: 15
Likes: 0
hey guys, no point in wasting forum space on a new thread, went out last night to run some errands and found a snow bank that enticed me a little too much, unfortunately my friend is a fail at taking good pictures so ive only got on from my iphone that shows how close my back end was to the ground.
Thread Starter
|
Member
Joined: Jan 2010
Posts: 15
Likes: 0
went out and washed the salt off the truck today (damn canadian winters) and noticed im getting quite a bit of rust along my passenger side half door and a little bit on my drivers side door along the bottom flange is this common on these trucks? also the metal parts of my front bumper and back bumper are really bad, but im just going to rhynoline them when the summer comes.
