|
The radio bezel just clips on.
Grab it with your fingernails to prevent scratching the dash and pull working your way all the way around.
after you have removed the bezel you will need to remove the four t20 torx head screws.
I have an aftermarket radio that had to be taken out prior to the EATC being removed, you may or may not have to do this but it sure makes it easier.
Gently pull the EATC out and up to clear the lower part of the dash.
Remove the 2 nuts that hold the vacuum lines and carefully remove the rubber manifold from the unit.
Unplug the 2 plugs and your out.
Total time to remove unit from the truck takes about 15 minutes.
|