Removing the oil pan - do I really have to raise the motor....
#1
Removing the oil pan - do I really have to raise the motor....
I need to remove the oil pan on my '97 f150 4x4 to replace the gasket and check out the bottom end of the motor. I'm confused because the Haynes book said I need to raise the motor and lower the front drive axle. However, after looking under the truck if I lower the front drive axle (after putting it on jacks) and remove the drive axle support bar between the frame I would have plenty room for removing the pan???
Is this possible or am I missing something? I need a brake job and alignment at the same time so this would fit into this project.....
Is this possible or am I missing something? I need a brake job and alignment at the same time so this would fit into this project.....
#4
I appreciate the input....so you are saying that the engine really does not need to be hoisted if I remove the front drive axle. I would pull the engine but since it would not be feasable in my garage because the truck it too long. It seems to be better if I could drop the drive axle on my driveway with the truck jacked up.
Dan
Dan
#5
#6
It's gonna be alot easier to just drop the axle out and work, beleive me, thats how i do em at work in the air, and its so much easier, something like 17-20 bolts/fasteners, and it will drop out... The axles will remain in the truck, just tie em back outa the way.... Just make sure to center the front diff on the floor jack good, and you will be fine... This would also be a good time to change the front diff fluid if it hasnt been done too.....
#7
Trending Topics
#9
I've been told (but never tried it myself) that you can loosen the bolts, drop the pan, and then remove the two bolts that hold the oil pickup on and let the pickup drop into the pan, then slide it right out without removing the front axle, or jacking the motor. Don't quote me on that. (I have a co-worker that works on Fords in his dad's shop on the side)
-Joe
-Joe