took my 02 f150 in to get pads/rotors done... well they forgot to tighten the bolts on the calipers so before i caught it, ruined the pass. side, i had to put in new rotor and pads, on them ofcourse, also waiting on a new RIM... so i'm kinda pissed... so i did the work myself, not bad, half hour i was done... but now my e-brake light is on? after about 15miles, what did i do wrong? it's not pulling at all, seems to drive fine, just the e-brake light is on??? i was going to head to the lake today so i would kind of like to figure this out???

 

do you have anti lock brakes - if so sensor may be damaged

 

update... light now just comes on under heavier braking... then goes back off???anyone else have any ideas?

 

Check ABS sensor, and check brake fluid and connections. These have caused problems in my mother's car before (X-Terra)