ABS wire corrosion
Thread Starter
|
Member
Joined: Jun 2000
Posts: 95
Likes: 0
From: Forest Hill, MD, USA
ABS wire corrosion
Can someone tell me where the wire or wire harness in question can be located. My ABS light is on and I have already replaced the rear diff. sensor. I would like to check out the possibility of a this wire corrosion issue. - Thanks
Junior Member
Joined: Feb 2005
Posts: 3
Likes: 0
From: windsor
corroded wire
you can check under the air filter tube . there should be your abs module. check for corrosion in/ on or around the wire plug. mine was the 4gauge red wire to that module. or you could just have a bad module
Thread Starter
|
Member
Joined: Jun 2000
Posts: 95
Likes: 0
From: Forest Hill, MD, USA
Well, I found the wire and sure enough it had a bulge about 1 inch from the ABS unit. Cut into it and got nothing out but green dust. I cleaned both ends back to good copper, tinned them and soldered them together. ABS light is now out (for now).