Wiring harness question -
Thread Starter
|
Junior Member
Joined: Dec 2008
Posts: 7
Likes: 0
From: Houston
Wiring harness question -
just changed the oil in my XLT 99, 4.6L
when pulling the oil filter, i noticed a second connector that splits off from the harness near the connector for the oil pressure switch .
never noticed it before. can't seem to locate where it goes.
had a shop change my oil last time because i was preping it for a road trip so i am not certain if this is for optional equipment that my model does not have or if the shop left something disconnected.
no CEL's or other trouble that I can recognize.
anyone know what this connector is for?
cannot locate it in my haynes manual.
Thanks,
Richard
when pulling the oil filter, i noticed a second connector that splits off from the harness near the connector for the oil pressure switch .
never noticed it before. can't seem to locate where it goes.
had a shop change my oil last time because i was preping it for a road trip so i am not certain if this is for optional equipment that my model does not have or if the shop left something disconnected.
no CEL's or other trouble that I can recognize.
anyone know what this connector is for?
cannot locate it in my haynes manual.
Thanks,
Richard
Member
Joined: Mar 2012
Posts: 19
Likes: 0
From: Beaufort, SC
just changed the oil in my XLT 99, 4.6L
when pulling the oil filter, i noticed a second connector that splits off from the harness near the connector for the oil pressure switch .
never noticed it before. can't seem to locate where it goes.
had a shop change my oil last time because i was preping it for a road trip so i am not certain if this is for optional equipment that my model does not have or if the shop left something disconnected.
no CEL's or other trouble that I can recognize.
anyone know what this connector is for?
cannot locate it in my haynes manual.
Thanks,
Richard
when pulling the oil filter, i noticed a second connector that splits off from the harness near the connector for the oil pressure switch .
never noticed it before. can't seem to locate where it goes.
had a shop change my oil last time because i was preping it for a road trip so i am not certain if this is for optional equipment that my model does not have or if the shop left something disconnected.
no CEL's or other trouble that I can recognize.
anyone know what this connector is for?
cannot locate it in my haynes manual.
Thanks,
Richard
Technical Article Contributor
Joined: Oct 2005
Posts: 25,641
Likes: 19
From: MI
It's a Electronic Variable Orifice (EVO) connect. In other words, a steering assist connector.
Yea, don't worry about it - it's nothing for that model. Some Expys and Navs had that set up.
Yea, don't worry about it - it's nothing for that model. Some Expys and Navs had that set up.