Okay so other than a little work on coil packs does everything else work ? Fuel rails , sencers, cooler lines ? Oh and yes the 05 4.6 is out of a truck.

 

There could be other things. oil filter relocation pulleys perhaps some sensors. I think it will work though with some work..

 

Okay then thanks just wanted some kinda heads up on problems that may arise

 

So I have an 02 Mustang GT with the 4.6L 2v, and a 99 Expedition XLT 4.6L Triton. Should I be able to pull the engine from my Mustang and drop it directly into the Expedition and go without any modifications, or will I have to make some changes? I'm relatively new to digging deep under the hood 😅😅

 

Oil pan and intake manifold would have to stay with the vehicle

99 4.6 is plug wires
02 is PI engine with COP

 

I am planning on swapping a 97 4.6 into a 2003. Both are winsor engine can I use the cops from the 03 on the 97 engine. I plan on using plenum from 03. Thanks for your help

 

Yes, you have to use the cops. You cannot use the 03 plenum, you need to use the 97 manifolds. The 03 is PI, the 97 is not. Different heads and manifolds.

 

Thanks, I can use the tb from 03.?

 

Ive got a 02 with W vin code and need another motor (lost oil pressure and locked up).will a 6 vin code out of an 03 work?
Mine is a 5 speed so ill have to swap flywheels but other than that, what do yall think

 

Yes, but you probably will not be able to use the 02 flywheel.

 

One is 6 bolt and one is 8 bolt right?

 

I believe so. New flywheels are not expensive.

https://www.rockauto.com/en/catalog/...,flywheel,5348

This may be a good time to replace the clutch and associated parts while the engines are out. Pressure plate, disc, slave/throwout bearing, pilot bearing, and rear main seal.

 

Clutch was just replaced 10k ago but thanks for the advice. All electrical should plug back in no issue right

 

Between 02 and 03, I would assume it will either plug and play or not be too difficult to modify.

I would still put a new rear main seal and pilot bearing in the donor engine and new flywheel.

 

I assumed the same.
Thanks for the assist