I know i have seen on here a link to a website with step by step pictures and directions for porting the throttle body and the elbow as well as halfing the shaft on the throttle plate. Does anyone have that link to the site?

 

X2 on that

 

Im pretty sure jbrew is the one that gave it out the first time i had seen it and i should have bookmarked it then. STUPID ME!!!!! I have found some directions here and there and a couple of good write ups on it but this site was awsome when i first looked at it!

 

i'll get back to you if i ever find the link.
i think i have it somewhere

 

Thats agood article. I have that one though. Theres another one out there floating somewhere.

 

No link that I know of . Post it up if you find one

 

if jbrew do know about it.
i sure i just thought i had it

 

I tried going through all of my posts but the list is too long and it deleated a bunch of mine from a long time ago. It was awsome! Hopefully i will find it.

 

LOL - Hey , I seen you posted that "Cleaning The TB" earlier Tumba

That's the closest most get to a Port and Polish ..

I just used a 3" wire wheel - Buffer and some Ruby Red to polish the TB. - Hoaned out the ports with small pipe cleaners.

If your talking about bumping the TB up to 75mm then porting the elbow. -

Neal, Faster150 and ONELOWF(spelling) has done it.. But no one posted a "how to" on the topic that I have seen..

 

Yeah.... I have seen neal's tb and elbow nad his tool list. Im guna do a write up on it and take pictures at the differnt stages in it. Hopefully i will get it done tomarrow. Then people wont be so lost.

 

Yea , do that . Since I polished mine and removed that anti-sludge crap Ford puts in the TB's, it hasn't accumulated dirt or any kind of deposits around the plate. I just tweaked the TPS to .99 from 1.20 and feels a little quicker under normal acceleration - it gets right to 55mph with less effort and the trans shifts are spread a little further from 2nd -3rd. I would suggest this mod to dial it in even better ..Actually it's not a mod , it's suppose to be @ .99 from what I gather- BUT !! Check it out , their not ..

 

Yeah you just went way over my head. I guessing a voltage reading is what your talking about. I stick to what i know so i was just planning on boring out the tb b4 the throttle plate to match teh back of the tb and also the elbo to get the most flow. If you share how to adjust the tps then i will do it and hopefully it will help too!

 

i'm interested in the tps thread also.

at this point the kids have taken all the fords from me.

i'm haven to drive a cruiser again.

i feel the need for clown makeup when i'm in that thang

 

I did the TPS threw an Analog meter - but it was acurrate, I checked it with two others to make sure.

Clown Makeup? Maybe a full face mask ehh

 

So how do we do it?