Missfire Cylinder 6

Thread Tools
 
Search this Thread
 
Old Dec 6, 2007 | 10:39 PM
  #16  
Shedstomper's Avatar
Thread Starter
|
Member
Joined: Dec 2007
Posts: 12
Likes: 0
From: Southern WV
Cleared the codes earlier today, and since then there isn't a solid light, it flashed and then went off. It usually does that a few times and then the light stays on solid.

It does it at all RPM's, but is worse under load.
 
Reply
Old Dec 10, 2007 | 09:16 AM
  #17  
Shedstomper's Avatar
Thread Starter
|
Member
Joined: Dec 2007
Posts: 12
Likes: 0
From: Southern WV
Watched the code this weekend and it has stayed the same. Is there anything else I can check to make sure it is the COPs? And is it common for them to go out close together like that? Just surprised that #1 would go out right after fixing #6.
 
Reply
Old Dec 10, 2007 | 09:38 AM
  #18  
JMC's Avatar
JMC
Technical Article Contributor
25 Year Member
Joined: Dec 1997
Posts: 9,417
Likes: 11
From: Windsor,Ontario,Canada
While the COPS may well last for over 150K the boots don't. I am still using the OEM COPS with well over 130K but the boots have been changed 2 or 3 times.

JMC
 
Reply
Old Dec 10, 2007 | 10:07 AM
  #19  
Shedstomper's Avatar
Thread Starter
|
Member
Joined: Dec 2007
Posts: 12
Likes: 0
From: Southern WV
Where can you get just the boots? I think that is my problem the boots are letting moisture in. The problem seems a lot worse when it is wet outside.
 
Reply
Old Dec 10, 2007 | 11:32 AM
  #20  
JMC's Avatar
JMC
Technical Article Contributor
25 Year Member
Joined: Dec 1997
Posts: 9,417
Likes: 11
From: Windsor,Ontario,Canada
Any car parts store should carry them or be able to order them. Napa, Autozone etc.

JMC
 
Reply




All times are GMT -4. The time now is 03:32 AM.