HEaders, Exhaust, Intake, etc, etc, etc
Thread Starter
|
Member
Joined: May 2006
Posts: 43
Likes: 0
From: San Clemente, CA
HEaders, Exhaust, Intake, etc, etc, etc
I have a 05 2wd 4.6 SCrew....my question is:
If I put on JBA Headers, Volant Intake and Banks or JBA Exhaust...and eventually an EDGE....what can I expect to have to change in my daily habits or experiences???
In other words:
Can I expect premature engine problems? Will I have to always run higher octane fuel? How much louder (on average) will it be?? Warranty issues?? Power gains??
Basically I am trying to anticipate the level of "change" in this......
If I put on JBA Headers, Volant Intake and Banks or JBA Exhaust...and eventually an EDGE....what can I expect to have to change in my daily habits or experiences???
In other words:
Can I expect premature engine problems? Will I have to always run higher octane fuel? How much louder (on average) will it be?? Warranty issues?? Power gains??
Basically I am trying to anticipate the level of "change" in this......
Senior Member
Joined: Jun 2005
Posts: 608
Likes: 0
From: Ruckersville VA
No forseen problems except development of a heavy right foot 
. I had almost the same mods at one time except for the tuner, and loved them. Made a big difference. Tuner should allow you to switch between 87 and 93 octane gas I believe.
. I had almost the same mods at one time except for the tuner, and loved them. Made a big difference. Tuner should allow you to switch between 87 and 93 octane gas I believe.