Washed engine - Won't Start
Technical Article Contributor
Joined: Oct 2005
Posts: 25,641
Likes: 19
From: MI
Originally Posted by kretinus
Oops never mind.
problem solved and a clean engine to boot
problem solved and a clean engine to boot
Holy H*** R U NUT'S?? You killed it!!! LOL , just kidding, it just happends alot, but no-one usually get's away with it...How did U??
Or did you ? lol
Thread Starter
|
Senior Member
Joined: Oct 2005
Posts: 335
Likes: 0
Originally Posted by jbrew
Holy H*** R U NUT'S?? You killed it!!! LOL , just kidding, it just happends alot, but no-one usually get's away with it...How did U??
Or did you ? lol
Or did you ? lol
Senior Member
Joined: Aug 2003
Posts: 1,921
Likes: 0
From: Susquehanna Valley, pa.
Originally Posted by kretinus
I spray everything down with Malco Red Thunder (1:2) let it set a few and then wash everything down with a 1300 PSI washer using a 30deg tip, never had any problems with it.
Thread Starter
|
Senior Member
Joined: Oct 2005
Posts: 335
Likes: 0
Originally Posted by lees99f150
I guess you cant state this anymore now.
Sure I can, the ignition wire was already shot before I washed the engine, it was just a coincidence that it finally failed after I washed the engine, it didn't even get wet.
Last edited by kretinus; May 7, 2006 at 05:15 PM.