This morning my power door lock did not work. The power unlock works fine. Has anyone seen or heard of this being a problem. It is quite cold today in New England and thus maybe a broken wire. I would like to think not. Is there a fuse that controls this. Again I think not.

Any suggestions would be helpful.

Thanks is advance,

 

Could you describe the problem in a little more detail?

For example: Driver's door switch will lock/unlock pass door only.

If that's the case it could be a bad actuator in drivers door, or crimped wire.

If passenger switch operates both locks, but driver's doesn't it could be a bad switch in driver's door.

The system is served by a 15A fuse in position 3.

 

Must have been a stuck actuator. I pressed on the unlock a few times and then back to the lock direction and it seems to have freed it up. It happened a couple of times so I might still need to do some maintenance to it at some time.

The original problem was that when I went to use the lock position on either door it would not do anything. The unlock side worked fine from either door.

Thanks for your help

 

Come on guys...lets keep questions in this forum related to 6 cyl engines