I finished my RCD lift on my 02 reg cab. I went ahead and cranked the torsion bars because i knew i was going to when i got tires and just by measuring to the bottom of the body i got about 1" maybe 1.5" lower in the rear. So i am wanting to know what size block to get in the rear to make it level. 2in? Thanks

 

I used a 6" block with my RCD lift rather then the 4" it came with. It leveled out nicely. There are some pics in my gallery.

 

put an add a leaf in it

 

well i already have a add a leaf thats wat it came with. So i figured a block would be the easier?

 

I'd try a lift block. Did the kit come with just an add-a-leaf or did it also include a lift block?

 

just a add-a-leaf.

 

Then I would replace the OEM 2 inch block with a taller one.

 

so just order like a 4in or what do you guys think? Also what brand? Thanks for the input guys

 

Yeah, if you replace the OEM 2 inch block with a 4 inch block that will give you 2 inches of lift. Blocks are pretty simple, so most any should be fine.

 

I'd go with a lift block or a leaf.

 

Congrats on the lift trx. Just so I can try and keep up, a block is basically a body lift right? I'm still wet behind the ears.

 

No a block goes between the leafspring and the axle.

 

gotcha. i probably sound like the forum idiot...but i'm learning.