I imagine this has been beat to death here but….this my first post and I was wondering if I could get a little advise from some of you. I'm going to install the Belltech lowering kit (3/4) this weekend on my 2001 Super Cab. When you're installing the front coils are they dropping the lower ball-joint or are they pulling the backside of the lower a-frame? Any other tips would greatly be appreciated.
Bob

 

Disassemble the ball joints, but be careful. As many have found out the hard way, it is easy to strip or crossthread the ball joints or nuts when you are tapping them out of the spindle, and you will never find a replacement nut for that odd size. Good luck!

 

Thanks, I'm aware that this subject has been beat to death, but it can hurt to ask. Thanks again.
Bob

 

darn, can't hurt!