Contemplating going lower? Pic of my truck. And some other stuff.
Thread Starter
|
Senior Member
Joined: Aug 2008
Posts: 107
Likes: 0
Did they tell you anything about the prep process?
Just a light surface abrasion, or did they take the chrome layer off?
It looks like you just went over brand new wheels?
They look great, and I'd like to do the same thing to some harley rims, but they're already pitting and peeling.
Just a light surface abrasion, or did they take the chrome layer off?
It looks like you just went over brand new wheels?
They look great, and I'd like to do the same thing to some harley rims, but they're already pitting and peeling.
And the back is as low as the front, its currently a 2/6 drop.
And so far, ive hit some knarly bumps and potholes with no problems. My dad measured travel and made sure he put the correct bump stops to keep it from hitting. It bottoms out, pretty much before hitting the fender.
Senior Member
Joined: Nov 2005
Posts: 17,118
Likes: 7
From: Burleson, Texas
Yeah, mine is like that too with the bump stops, that's why I won't cut them. I'm at a 2/4 GF coil/leaf drop.
I was meaning with another inch lower up front it'll be close if you don't watch out and do the math.
I was meaning with another inch lower up front it'll be close if you don't watch out and do the math.
Senior Member
Joined: Feb 2010
Posts: 203
Likes: 0
From: Over in that one part of GA
I didn't know for sure or not, it looked kinda back high by the one picture but that's just me.
I'd say body drop it if you could..
I'd say body drop it if you could..