Hey guys. I'm trying to put a whole system together for a guy I ran into at the gas station. I did a quick glance at his 09 supercrew about an hour ago but couldn't find my tape measure. I'm wanting to measure under the driver's side seat and see what the following measurements are.

a. from the bottom of the seat to the floor area that is flat just before it goes up behind the seat.

b. from the front edge of the seat to the floor

c. on-the-floor measurement from the front edge of the seat to the back just before the floor rises up.

Hope that all made sense. I just want to put a single 10 or 12 under his seat. After looking at the truck it looks like we could get away with a standard behind the seat truck wedge enclosure. Otherwise I will need to build something.

 

Not sure if this will help you, But the jlw1v2 work really well inside of small enclosures. Check out SUBTHUMP.com I know they make downfiring boxes up to the 08 model with a single or a double configuation. That being said my brother inlaw just bought an 09 today I think if you look at ther boxes on line if you can make something close to what they do I think you can get 4 10's under that seat because it is flat. Just my 2 cents

Mark

 

I got four 09 trucks to work on tomorrow. I'll get the measurements then and I'll take a truck wedge box with me. I'll post my findings for you guys.

 

I see you're in KC. I have some things I was thinking about getting done. Exactly where are you located at? I'm in Grain Valley.

 

Grain Valley. We just recently had to close down our indoor skateboard park there. Really sad. Had the best ramps in Kansas City. Nobody wanted to help pay for it so we closed the warehouse down. As for me....no store front. I'm a mobile guy located in Independence. Been that way for years. Just too expensive to have a shop these days. Plus then I'd have to hire employees that would steal money or business from me...lol

 

You could always come to Savannah!