I was thinking about Removing the back seats, and buying two front seats and placing them in the back? Would they fit or has anyone tried.

So i could set it up like

Seat Sub Seat


No clue just had this idea since the seats are plated and you cant just take the single seat out . That would make my life so much easier.

 

I though about it, but I didnt think two front seats would fit at all, or really look that good, in the back (this is in my 99 Scab).

I also though about the rear seats out of a SCrew Harley, but scratched that for various reasons.
One of the better ideas was to take 2 of the '40' sections and place one on either side...

 

Mines a 99 XLT. extended. Same as yours i believe.

Im thinking two seats if theyll fit. Anyone confirm doing or tyring this? think im gonna measure tomorrow. Hell i might just go to the local junk yard and find something that fits

 

just though, probably absolutley no leg room if you stick buckets in the back too. My guess is it would be about worthless to put buckets back there, as no one could probably fit; Unless you have lots of midget friends whos legs dont hang over the edge of the seats

 

http://cgi.ebay.com/ebaymotors/Full-...QQcmdZViewItem

something like this?

 

Yeah. Heck, you never know till you try, and you should be able to get a pair of buckets out of a junk yard fairly cheap. Give it a shot...I guess I just wouldnt be suprised if they didnt fit to well, or didnt have any people room afterwards...I dunno.

 

This isn’t exactly what you’re doing but it might give you some ideas in case you haven’t seen it already.

https://www.f150online.com/forums/sh...=217484&page=1

From what I understand this is basically what you want to do only this guy used factory rear seats.