Top Stabilizer end link nut
#1
Top Stabilizer end link nut
Ok guys, i changed out my lower ball joint and tierod ends the other day. This morning was time for the Stabilizer end links. I soak everything down with pb blaster and driver side 14mm top nut just spins. Went over to the other side and no problem with it coming off. Whats the easiest way to remove?
Also, you are suppose to hold the 18mm lower nut with a wrench and turn the 8mm spindle clockwise or counter clockwise when looking straight up. That sucker is tight too. Thanks guys
Also, you are suppose to hold the 18mm lower nut with a wrench and turn the 8mm spindle clockwise or counter clockwise when looking straight up. That sucker is tight too. Thanks guys
#2
#3
#5
Ok here's the setup.The top nut abou the washer is just spinning. I'll put a jack under the A arm and apply some pressure but if that doesn't work do i have the spindle off?
Also, on the bottom u der the A arm, do i hold the 8mm hex and turns the 18mm nut or is it the other way around? What direction do i turn?
Which way do u turn it
Also, on the bottom u der the A arm, do i hold the 8mm hex and turns the 18mm nut or is it the other way around? What direction do i turn?
Which way do u turn it