The rubber seal that fits on the front of the passenger side rear SCAB door came off. It is all intact but I don't seem to be smart enough to put it back on. It fits in a "channel" at the front of the door. Do you push it into the channel or start at the top or bottom and slide it in that way. Hope I am making this clear enough because I have no idea how to post a picture. Thanks, Jim.

 

I think I know what you are talking about. You should be able to start anywhere you want, but I would think you would want to start at one of the ends. If I remember correctly, the front just goes a couple of inches under the plastic molding.

My drivers side one seems to have shrunk over the years and I constantly have to push it back up.