Latest Dyno Results
Thread Starter
|
Senior Member
Joined: Nov 2001
Posts: 2,042
Likes: 0
From: Redmond, Wa
Latest Dyno Results
Got my truck on the Dyno today...Made some great numbers with the MAC catback and my R.E.M. tuned Diablo Delta chip..
These numbers were taken on a MUSTANG DYNAMOMETER so they reflect "under load" numbers.
it was a hot one in the dyno area (around 90 degrees)
:
program 1: 396.9 RWHP @ 4750 RPM 457.3 RWTQ @ 4500 RPM
program 2: 401.2 RWHP @ 4750 RPM 461.8 RWTQ @ 4500 RPM
I don't see any power loss from the MAC
.....JR
These numbers were taken on a MUSTANG DYNAMOMETER so they reflect "under load" numbers.
it was a hot one in the dyno area (around 90 degrees)
:program 1: 396.9 RWHP @ 4750 RPM 457.3 RWTQ @ 4500 RPM
program 2: 401.2 RWHP @ 4750 RPM 461.8 RWTQ @ 4500 RPM
I don't see any power loss from the MAC
.....JR
Thread Starter
|
Senior Member
Joined: Nov 2001
Posts: 2,042
Likes: 0
From: Redmond, Wa
Re: yeah!
Originally posted by Coldie
You did a full 5 gas run, right? Spit up the details!
Coldie
You did a full 5 gas run, right? Spit up the details!
Coldie
my A/f ratio was around 13.2 after the cats...It's a little on the lean side, that has already been taken care of though...
Senior Member
Joined: Sep 2001
Posts: 4,342
Likes: 0
From: Motor City
Re: Re: yeah!
Originally posted by SLVRLTNG
my A/f ratio was around 13.2 after the cats...It's a little on the lean side, that has already been taken care of though.
my A/f ratio was around 13.2 after the cats...It's a little on the lean side, that has already been taken care of though.
Did your engine compartment sound like popcorn??
--Joe
Trending Topics
Senior Member
Joined: Dec 2001
Posts: 4,081
Likes: 0
From: Dyer, IN
I just dynoed mine at indy truck bash.... saw speedin bob there.. very cool guy. anyways I had to dyno with only the street chip cause i couldnt find any race fuel!!
oh well I made 368hp and 519ft lbs of torque( tops for all pulls,made three) and this was in 85 degree heat with about 5min cooldown time. I fugred my horsepower would be higher, especially with a 5lb pulley but oh well... i dont get it...
oh well I made 368hp and 519ft lbs of torque( tops for all pulls,made three) and this was in 85 degree heat with about 5min cooldown time. I fugred my horsepower would be higher, especially with a 5lb pulley but oh well... i dont get it...
Last edited by blown318; Aug 18, 2002 at 11:35 PM.
