Pics of my nitrous setup...

Reply Subscribe

Thread Tools

Search this Thread

Feb 4, 2002 | 08:21 PM

NXsilversvt

Thread Starter

Member

Joined: Oct 2001

Posts: 47

Likes: 0

From: Laramie, WY

Pics of my nitrous setup...

I got bored earlier, so I decided to take some pics of my nitrous setup for you guys. Let me know what you think...

Bed of the truck (complete with slicks and nitrous):
http://www.imagestation.com/picture/...b/fdf41507.jpg

Closer-up pics of bottle (w/bottle blanket, heater, and remote opener):
http://www.imagestation.com/picture/...e/fdf41505.jpg

Nitrous switches (I believe I'm the only one with this setup):
http://www.imagestation.com/picture/...7/fdf41503.jpg

Engine bay:
http://www.imagestation.com/picture/...b/fdf414fd.jpg

Close up of purge/nitrous/fuel solenoids, lines, and nozzle:
http://www.imagestation.com/picture/...b/fdf414ff.jpg

My Autometer nitrous/boost gauges w/painted pod:
http://www.imagestation.com/picture/...6/fdf41316.jpg

Feb 4, 2002 | 08:24 PM

Silver-Bolt

Senior Member

Joined: Dec 2000

Posts: 3,451

Likes: 0

From: Portland, Oregon. USA

Is it injecting into the rubber boot? Might want to check out the PSP throttle body plate. How big of shot you running?

Feb 4, 2002 | 08:24 PM

Lightning Boy

Senior Member

Joined: Jan 2000

Posts: 1,300

Likes: 0

From: Sugar Land, Texas

Looks good. But in my personal I taste, I dont like seeing all the wires around the bottle like that. Im also kind of consered about the silinoids being on the motor like that.

Feb 4, 2002 | 08:25 PM

PhillipSVT

Senior Member

Joined: Sep 2001

Posts: 2,144

Likes: 0

look's nice.

and one question for a person who know's nothing about NOS, what is this stage 1 and stage 2 stuff?

Feb 4, 2002 | 08:31 PM

ICULOKN

Senior Member

Joined: Oct 2001

Posts: 4,815

Likes: 0

From: Richmond,VA

Looks good!!! Take a picture of it purging!!!

Feb 4, 2002 | 08:33 PM

NXsilversvt

Thread Starter

Member

Joined: Oct 2001

Posts: 47

Likes: 0

From: Laramie, WY

Yes, the nozzle is injecting into the rubber boot, but it'll be fine. I've seen guys run 250 shots like that. There is a nut securing the nozzle inside the boot. I'm just on a 75 shot until I get a chip to back off the timing a bit. It'll never go over a 100 shot, though. As for the wires... I know, I know... I've got some cleaning up to do because I just installed my Bedrug and didn't have a wire loom to neaten them up :o . I used to have the bottle in a yellow Craftsman toolbox to hide it, but everyone knows about it now anyway and the toolbox looked ugly. As for someone saying they were concerned about the solenoids being on the motor... I'm curious, what should I be concerned about? I've run about 4-5 bottles through it so far and put at least 5k miles on the truck since the kit was installed with no problems.

Last edited by NXsilversvt; Feb 4, 2002 at 08:37 PM.