Cruise Switch Recall
Senior Member
Joined: Nov 2003
Posts: 395
Likes: 0
From: Buford, GA
Right on Justin 
. I sure as heck down want Ford to touch my truck again, but Im not going to risk any liability. I had a guy come into work (Autozone) a month ago who actually had is 98 f-150 burn to the ground! seriously 
. I sure as heck down want Ford to touch my truck again, but Im not going to risk any liability. I had a guy come into work (Autozone) a month ago who actually had is 98 f-150 burn to the ground! seriously
Senior Member
Joined: Jan 2003
Posts: 414
Likes: 0
From: Valdosta Ga.
Get this done guy at all cost. I just put out my 2nd house fire because of this faulty switch. Thanks god the people has plywood sealing in their garage and it did not brun into the 2nd floor. 4 if my guys including me drive effected Ford or is that infected we all went back and has a disconnect and zip ite party after. Jan 4 2005 was the 1st fire with a total lose of a 6000sq/ft house thet tried to puyt it out by themselves for 20mins before they dialed 911. The 1st truck was a 2001 F120, the 2nd one 10/07/2005 was a 2002 Expy. SO get this done by Ford before it is TOO late.
Jeff
Jeff
Senior Member
Joined: Oct 2000
Posts: 507
Likes: 0
From: " Somewhere Between Lost & Found "
Ithought it was 99-02 recall only ! 
P.S. Took it in for the fix and they screwed my dashlights up, intermittent flashing on and off radio read-out and cluster. what asshats ! why do I go back there ?
P.S. Took it in for the fix and they screwed my dashlights up, intermittent flashing on and off radio read-out and cluster. what asshats ! why do I go back there ?
Last edited by SMOKINTRUCK#1; Oct 28, 2005 at 11:23 PM. Reason: FAULTY MECHANIC
Member
Joined: Mar 2005
Posts: 28
Likes: 0
From: Pennsylvania
Deep into this link:
http://www.nhtoc.com/forum/showthre...ll&pagenumber=2,
the poster said to remove the old switch with a 14mm stubby open end.
'Tain't true. I changed mine yesterday morning and what fits is a 9/16" open end that I bent into a right angle to loosen old-timey distributor hold-downs.
The 14mm is a tad too small.
The 7/8" deep socket used to install the new one is correct.
http://www.nhtoc.com/forum/showthre...ll&pagenumber=2,
the poster said to remove the old switch with a 14mm stubby open end.
'Tain't true. I changed mine yesterday morning and what fits is a 9/16" open end that I bent into a right angle to loosen old-timey distributor hold-downs.
The 14mm is a tad too small.
The 7/8" deep socket used to install the new one is correct.
Senior Member
Joined: Oct 2000
Posts: 507
Likes: 0
From: " Somewhere Between Lost & Found "
Bump!!
Originally Posted by SMOKINTRUCK#1
Ithought it was 99-02 recall only ! P.S. Took it in for the fix and they screwed my dashlights up, intermittent flashing on and off radio read-out and cluster. what asshats ! why do I go back there ?
P.S. Took it in for the fix and they screwed my dashlights up, intermittent flashing on and off radio read-out and cluster. what asshats ! why do I go back there ?