Has anyone ever used the Ruslow Heim kit with the rear shocks that come with the Roush suspension kit? Stan noted that the Heim kit is set up for a 5/8" 20 thread pattern, but I was unable to locate a nut with this thread pattern in order to check the Bilsteins. Any feedback would be much appreciated.

 

After I typed that I think it is 18.but in either case it is National Fine thread standard.stan

 

Stan:

Is there any drilling required to mount your Heim bracket to the stock shock bracket?

 

nope just a socket and a wrench.Stan

 

Well Stan, I arrived home today to a brand new Roush kit on my door step. I pulled the shocks out and sure enough the rods are 3/8". I am going to go out on a limb here, but I would have to say that there is a market for your Heim kit with a the Heim joint that would accept the 3/8" Bilstiens. I dont know who supplies you with the Heim joints, but I can't foresee it being terribly difficult to find a Heim joint in a 3/8" thread pattern. I for one would be happy to pay for a kit if you are able to acquire the 3/8" Heim joint. Please look into the possibility and let us know if you can make it work!

Thanks for your time Stan,

~Todd