Porting the Eaton
Thread Starter
|
Senior Member
Joined: Aug 2003
Posts: 163
Likes: 0
From: Imperial County,Ca
Porting the Eaton
Reading about the results from porting the Eaton I decided to do it myself. I am going to remove about a 1/4" from the bottom outlet and make those sloted holes a bit bigger. Any suggestions?
Senior Member
Joined: Jan 2003
Posts: 5,097
Likes: 0
From: DETROIT, (formerly Eaton County, Michigan)
well before you go hacking it up think about this.
DYNAMIC ported an eaton and was all excited about the gains and it resulted in ZERO gain.
Just making the hole biger may give you something, but there is much more to porting than just enlarging the holes.
Search on NLOC and you'll find the posts regarding Apten's SUCCESS and Dynamics Failure.
DYNAMIC ported an eaton and was all excited about the gains and it resulted in ZERO gain.
Just making the hole biger may give you something, but there is much more to porting than just enlarging the holes.
Search on NLOC and you'll find the posts regarding Apten's SUCCESS and Dynamics Failure.
