diablo chip
4lb lower pully
1lb upper
throttle body
cold air intake
borla exhast,
line mod valve
electric fan
cobra R water pump
boost bypass



please, thank you

 

I go .038 or .040

Some go smaller

Can't go wrong with .038

 

so .038 is a safe bet

 

Moshe! Long time no see

I just ordered my JDM stuff this week, should be in by Tuesday! Now I can almost keep up with you lol

We are heading up to Cayuga on Apr. 4, if you would like to come, just call

This is Moe by the way

 

moe call me 416-678-3521

 

ND said not to gap them, and be careful if you do.

http://www.runninwiththedevil.com/densoiridiumfaq.htm

 

Rob told me .038 months ago and I did. Everything goes well!

 

QUOTED BY IRIDIUM POWER DOT COM
In the cases of vehicle modifications (nitrous, turbo-chargers, super-chargers, high power ignition systems, etc.), some adjustments may be desired. Or, if you prefer to remain consistent with factory specifications, you may adjust. However, please be careful not to place any stress on the fine center electrode during adjustment. You could accidentally break off the very hard, and therefore brittle, tip.
IT22 are Factory set @ .044
END OF QUOTE


.044 is too big for "Higher Boost Supercharged Engines"

Some even gap as small as .035
I find .038 - .040 just perfect

 

i'm gapped at .034

because the big man (sal) recommended it