Duly noted Raptor, thanks for the reply.

OP, I apologize for hijacking your thread.

 

benchwarmer- yeah i did that the other day their H1's as well so im curious if i can use an H3 cause to me they look similar but i dont know much about it

 

They're physically different sizes, and the filament runs in opposite directions inside the bulb as well, I believe. Not sure how that will affect the light output from the projector (which I'm sure is already lacking.) If it were me I'd just get a quality H1 bulb and also mod your low beam projector to stay on when you switch your high beams on. It's pretty simple to do.

 

alright thanks bench

 

Also, if you do mod your low beams to stay on with your high beams, you'll need to check your fuse size for the high beam headlamps to make sure it is rated for the extra current draw. It'll run around 18amps. I think it's a 20A fuse in the 2006; but you would need to verify that. It's only a 15A in my 2011.