|
Updates?
|
Originally Posted by Stormsearch
(Post 4686466)
You have to cut the inner part of the shroud so they fit as deep as possible before bottoming out on the HID reflector. My projector lens actually sticks out past the shroud and is only about 1/8" from the lens.
|
Originally Posted by ak_cowboy
(Post 4708178)
How did you trim the inner part of your shroud? I'm thinking a small cutting blade in my dremel... That's the only part that's holding me up. Well, that and ordering a new CCFL...:(
|
Sweet. I'll probably get my fogs done up when I'm at my grandparents over thanksgiving. Going to wire them up the same as my other off road lights. Factory switch to turn them on, toggle switch for high beam, and relay to highbeam with the highbeam heads :peace:
|
Yeah I used a sanding drum and made 5 slots. 4 slots to go around the post brackets on the projectors, and one bigger slot for the highbeam relay. I think i'm going to sink the shroud deeper into the bowl.
https://www.f150online.com/forums/me...4-img-1440.jpg And to cut the tabs to sink the shroud deeper I used a cutoff wheel like in the next picture. https://www.f150online.com/forums/me...e146834-19.jpg And cutting the back small tabs. https://www.f150online.com/forums/me...e146833-20.jpg . |
^ that cutoff wheel is what I was thinking of. The one that I have right now is too big
|
| All times are GMT -4. The time now is 02:52 AM. |
© 2024 MH Sub I, LLC dba Internet Brands