Let's start over......

Good news is that I finally got my Cavi's front brake rotors off. One of them has a nice gouge in it, but the parts store said it was saveable, which is good. Gonna replace the pads and the right front wheel bearing tomorrow. Only lasted 249K miles... Well, its still good (no play or vibrations), but its noisy at about 45 MPH. Its been like that since I bought it (240K), and god knows how long the old owner drove it like that. Crap! I just remembered I need to change its oil too.

I'm gone, don't miss 24!
__________________
Jim
Jim
I will not miss 24, even if I have to drive home to watch and then come back to work!
Enjoy the show!
Enjoy the show!
LOL... Just got this in an email from my boss about his Chevy truck
you haven't got a clue yet about my knowledge on vehicules...we got it fixed with rubber off a tire intertube and clamps...such is mexico...
you haven't got a clue yet about my knowledge on vehicules...we got it fixed with rubber off a tire intertube and clamps...such is mexico...
Morning all.
I'd like to get your opinions on a new FX4 sticker I made for my truck. Eventually I'd like to get everything on the exterior red, black and dark gray. I just put on some patriot decals that are fiber carbon over the ovals front and rear. Can't decide if I should remove the FX4 altogether or use this one I made. Thanks!
I'd like to get your opinions on a new FX4 sticker I made for my truck. Eventually I'd like to get everything on the exterior red, black and dark gray. I just put on some patriot decals that are fiber carbon over the ovals front and rear. Can't decide if I should remove the FX4 altogether or use this one I made. Thanks!
Morning all.
I'd like to get your opinions on a new FX4 sticker I made for my truck. Eventually I'd like to get everything on the exterior red, black and dark gray. I just put on some patriot decals that are fiber carbon over the ovals front and rear. Can't decide if I should remove the FX4 altogether or use this one I made. Thanks!

I'd like to get your opinions on a new FX4 sticker I made for my truck. Eventually I'd like to get everything on the exterior red, black and dark gray. I just put on some patriot decals that are fiber carbon over the ovals front and rear. Can't decide if I should remove the FX4 altogether or use this one I made. Thanks!





