Let's start over......
03-25-2011, 07:54 AM
Senior Member
Join Date: Nov 2007
Location: In a house, in a small town
Posts: 1,845
Likes: 0
Received 0 Likes
on
0 Posts
Thinkin of getting these since I'm about due for brakes and rotors. I think this is the set that some guys here have used with good results.
http://cgi.ebay.com/ebaymotors/4WD-D...Q5fAccessories
http://cgi.ebay.com/ebaymotors/4WD-D...Q5fAccessories
03-25-2011, 07:57 AM
Senior Member
Join Date: Nov 2007
Location: In a house, in a small town
Posts: 1,845
Likes: 0
Received 0 Likes
on
0 Posts
03-25-2011, 08:28 AM
Senior Member
03-25-2011, 08:36 AM
Senior Member
Join Date: Nov 2007
Location: In a house, in a small town
Posts: 1,845
Likes: 0
Received 0 Likes
on
0 Posts
No, but when I was shopping for my last set of clubs I tried a set regular graphite shafts and my dad said I was putting a really nice arc in the shafts on my down swing. I only have two clubs in my bag that have graphite shafts and that's my driver and three wood and I had to special order them to get the stiff shaft the rest are steel shafts.
but when I was shopping for my last set of clubs I tried a set regular graphite shafts and my dad said I was putting a really nice arc in the shafts on my down swing. I only have two clubs in my bag that have graphite shafts and that's my driver and three wood and I had to special order them to get the stiff shaft the rest are steel shafts.
03-25-2011, 08:59 AM
Senior Member
No, but when I was shopping for my last set of clubs I tried a set regular graphite shafts and my dad said I was putting a really nice arc in the shafts on my down swing. I only have two clubs in my bag that have graphite shafts and that's my driver and three wood and I had to special order them to get the stiff shaft the rest are steel shafts.
but when I was shopping for my last set of clubs I tried a set regular graphite shafts and my dad said I was putting a really nice arc in the shafts on my down swing. I only have two clubs in my bag that have graphite shafts and that's my driver and three wood and I had to special order them to get the stiff shaft the rest are steel shafts.
03-25-2011, 09:10 AM
Senior Member
Join Date: Nov 2007
Location: In a house, in a small town
Posts: 1,845
Likes: 0
Received 0 Likes
on
0 Posts
03-25-2011, 09:12 AM
My poor truck is so filthy. This country life is hard on a clean truck, but the worst part is the East Texas bugs. Had to wash the windshield last night so I could see. Headed for Burleson after work, will get to bed late, then up early in the morning to go to Frisco to see Patrick. He's replacing A arms and ball joints and doing an alignment.
__________________
Jim
Jim
Last edited by Bluejay; 03-25-2011 at 09:18 AM.