I've searched and could not find any info except on '09+ F150's. Has anyone done the swap on an '04-'08 F150? I like the look of dual tips on the same side and it could be an inexpensive alternative to full custom or aftermarket exhaust. Not looking to make it louder, just look better.

 

Even less expensive:

 

That's not slash cut to work as a side exit.

 

Just put the tips or a portion on. Not sure how much you're planning on adding, but swapping the whole thing, muffler and all, wouldn't be worth doing.

 

You can find single to dual tips that are slash cut. I just posted that as an example.

 

I put on a SI/DO Borla PRO XS took it to a muffler shop and told them I would like the tail pipes to exit like the raptor. They cut the slash for me.

 

x3 on the not worth it part. Find a tip on Summit Racing.

 

Just an FYI...those exhausts are crap. Big ugly muffler and I saw a few that weren't even mandrel bent at the dealer. Cheaping out hardcore. Hard pass.

 

I got one for free full cat back off a raptor I just bought an adapter piece for $20 and put in in myself easy decent mod if your on a budget doesn't do much for performance but looks and sounds ok

 

My cousin did on his 06 F150 I believe it was a bolt on swap, and it sounds more throaty

 

Thanks for all the replies. Just looking at it from a budget stand point. I can get the exhaust for next to nothing which is good especially since it's a direct bolt on. I can swap mufflers later when budget allows.

I'll look at all the options before going forward. Main concern was if it was direct fit or not. Thanks again.

Schorrsy - Can you post pics of your install please?

 

So... I'm still a little new here how do you put pics in your reply?

 

https://www.f150online.com/forums/qu...-pictures.html

 

http://cimg1.ibsrv.net/gimg/www.f150online.com-vbulletin/2000x2000/80-20141124_064451_bdc587991e64b5637f0f0a1631e3b4631c 061381.jpg

 

I should probably get to work but here's the link to my album. I'll figure this pictures thing out later lol thanks for the link though!
https://www.f150online.com/g/album/2612719

And if you look were the new piece of pipe is welded in, they did that when I got my headers installed. it used to be a piece of exhaust pipe expanded at one end to go from 2.5"-3" with U clamps at either end. that was the only thing I had to do to get the raptor exhaust in. The only other hard part was getting it over the rear diff.