this may be a newb of a question but, i can handle the criticism.

i seen on an older thread where someone said they installed their exhaust without cutting the old one and it only took a few hand tools.

do you not need to weld it up anymore? do the clamps that are supplied make a good enough seal?

i was looking at the magnaflow kits and this got me thinking if i could do it myself.

 

Heck yea you can do it yourself!

Altho it'll take more than a few hand tools.

And the clamps seal like crap. So unless you can make a good weld and have a welder and a sawzall, bench vise and a little know how its easy to do.

If you dont have access to a welder or cant weld, then dont do it just have a shop do it. Itll be worth the extra money to not have it fall apart