Had a local shop custom fab it together...they started at the Y and ran a 3inch pipe to the new magnaflow muffler then two 2 1/2 inch tail pipes out to the 20" x 3 1/2" magnaflow chrome tips.

Sounds clean !!! ...no poping or throthy sounds...just clean Magnaflow sound...sorry not able to post up a sound file.

 

Looks good.

 

You can get away with out using the cats!

 

That would sound awful, atleast add hi-flow cats.

 

my cats are still there we started from the Y conection after the cats...

I'm up in the air right now on tossing on some hi flow cats....
just need to see if I can find some hi flows with a bung connector on them for the o2 sensors....unless I don't have to even hook those sensors back up and it does not cause any issues...I will have to do a bit more reserch.

 

Magnaflow offers those cats, and I believe you can re-mount that last sensor after the hi-flow cat with no codes but i'm not guaranteeing it because I dont have an 06+ 2 cat system.

 

I wonder what those hi flow cats would cost as freeing up some more sound would be nice but at what cost is the question.

 

yea x2 no cats would sound bad, and i like how you ran those tips, ive always liked that exit too

 

Nice setup. You must've drove that from dealer lot to muffler shop, sure does look clean on the underside!

I've been looking for a kit something like this but can't find one.
I’m looking for true duals with X then two si/so mufflers then both exhausts running out to the back side of passenger tire.
I can't find a kit that has dual exhaust on back side of passenger tire.
Any ideas?
Am I gonna have to have muffler shop make this?

 

$55 - $78 each. You can either go with part #s 94306, 94006, 94106. Those are in order from largest to smallest.

 

perfect those seem affordable but do they have a place for the 02 sensors as they don't list that info in the discription ?

 

I'm not sure where you can find any kits as I never did look but any good exhaust shop shuld be able to fabricate what ever you like.

 

no they dont.

 

Are those tips 45* cut? That's how I want mine, but in front of the tire...

 

yes they are 45* cuts