Well i started doing mt headers this morning at 11... all went pretty good on the drivers side, except one bolt thats impossable to get to... but thats not my proublem... the pass side... i cant get the #$%^&* thing in there.... what the hell do i need to do? i called pasesetter for a hand, they told me that they dont make anything for the 4.6!!! i know yall have dont it... how did you get it in there? i need to get my truck back tomorrow. and thats all thats holding me back... will someone please help me? im going to bed now and ill be back at it at 9 tomorrow morning, and i really need to figure this out... thx for your help ill be up for a bit longer... if you have questions.. just ask

 

well i guess, im going to get back to tring to ge it on there. ill still check back on here if someone can help. I'll be on my yahoo messinger on my phone Im id polpilot...

 

Take the passenger wheel & wheel well guard out, and just try try try, its a real PITA on these trucks.

 

I got it... it was a pain. i had to unbolt ***** motor mounts and lift it up and it slid right in... w/ a little force... haha i love the sound of it open it has to wait till tues to get finished... here a clip of me pulling out of the bay...
http://www.youtube.com/watch?v=znA0vOvn_cI

 

other then original fitment do you have any clearance or rubbing issues on the frame or starter?

 

pretty wicked! Good to hear you have them installed.

 

I think its touching the frame on one side but i cant remember i know its not touching the starter.... ill let you know for sure tomorrow when its light...