led turn signal wireup: should i put a fuse?
Thread Starter
|
Senior Member
Joined: May 2006
Posts: 241
Likes: 0
From: Hawaii
led turn signal wireup: should i put a fuse?
im almost done wiring up my powered mirror with led turn signals. just want to make sure before i finalize my wiring. should i put an inline fuse to the wire that's connected to the turn signal wire, or will vampire tapping directly to it will be just as fine? thx
Technical Article Contributor
Joined: Jun 2002
Posts: 10,511
Likes: 10
From: Under the flightpath of old ORD 22R
On my '95 and '01 when I added the Muth mirrors, I did the direct T-Tap on the '95, and the '01 was installed directly into the factory harness location at the connector in the door, no additional fuses.
Factory harness does not use an additional fuse, so you should be good with a direct wire, as long as you do not pinch the wires anywhere.
'05 should be in the door, so a fuse would be a pain to get to anyway.
Factory harness does not use an additional fuse, so you should be good with a direct wire, as long as you do not pinch the wires anywhere.
'05 should be in the door, so a fuse would be a pain to get to anyway.