Today i tried to install my Hypertech programmer again. I plugged it in to the computer, turned the key to runand nothing happened. The status light on the prgrammer just flickered once. So i thought maybe it was just the programmer. Then i tried my code reader and nothing even registered on that. It doesnt even turn on.I am lost on what to do and i'm not an expert on electrical stuff. Does anyone know what could be wrong? Thanks guys.
2001 F150
4.6l 110,000 miles.

 

Look for either a fuse problem ot a bent/pushed pin in the port connector.

 

I checked the pins and they were all straight i'll check fuses next. Thanks!